Duct Cleaning Offers a Simple, Affordable Solution for Enhancing your Indoor Air Quality
Your water heater is one rather used and much more costly appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving from the home heating and costs.
Regular flushing of the water heater are probably the single most important step you get to prolong its service life and even save energy. In a period of time, sediments build up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most involving the country, the common water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is in today’s markets. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.
To drain your water heater, you can find should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is definitely an electric heater). Failure to do so could result in overheating and severe damage to water heater. Next, close the water supply valve located in the water inlet line going into your water heater. You can then connect a hose to the drain valve located towards the end of the space heater. Open the drain and allow it to move until all for the water has emptied from the heater. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until water flows out smoothly. This will allow air to vent via the heater and the water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so may less corrosive to your plumbing system, particularly in areas possess hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to fit the bill.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610
